• General Machine Work
• Block Work
• Engine Balancing
• Engine Kits
• Crank Work

• Head Milling
• Head Work
• Piston Work
• Connecting Rod Work

General Machine Work

Assemble Short Block (Extra for Tight End Gap Motors)
Assemble Motor with Heads, Pan, Oil Pump, Rockers, Intake Manifold (No Carburetors, Fuel Pumps, Flywheels, Ignition or Exhaust Manifold)
Check Piston to Head Clearance w/o Assembly
Check Piston to Head Clearance with Assembly
Check Piston to Valve Clearance w/o Assembly
Check Piston to Valve Clearance with Assembly
Degree Cam w/o Assembly
Degree Cam with Assembly
Compute Compression
Degree Balancer 0 - 60°
Disassemble Short Block
Disassemble Complete Block
Drill Bearings

Block Work

Engine Balancing

Balance Piston, Rod & Crank
Balance Complete Assembly
Balance Counterbalanced Type-Pistons, Rods, Crank, Flywheel-Harm, Balancer-Clutch
Extra Charge for Overbalancing
Extra for Each Plug Welded in Crank Holes
Extra for Each Plug of Heavy Mint Drilled & Welded
Match Crankshafts to Pre-Balanced Rods & Pistons (Standard Balance/Dependent Balance)
Flywheel
Clutch
Harmonic Balancer
Rods
Pistons

Engine Kits

Crank Work

Check for Straightness and Mike
Polish and Boil
Radius Oil Holes
Cross Drill
Grind & Polish
Blueprint, Check & Polish
Drill & Tap for Balancer Bolt
Magnaflux
Straighten
True Flywheel Flange

Head Milling

CC & Mill (1 Chamber)
CC & Mill including Intake (NHRA LEGAL)
Cleanup Mill Up to .015 No Intake
Mill including Intake Surface
Angle Mill
Extra for Milling Intake Surface on All Stepped Type
Mill Intake Surface Only
Mill Intake Surface Only (Stepped Type Heads)

Head Work

Disassemble and Boil
Glass Peen
Assemble and Shim Stock Springs (Race Heads Extra)
Grind Valve Seats
Peen and Reface Valves
Blueprint Valve Job (includes all the above)
Competition Valve Job (Set to Race Cam Specs)
Bore and Install Cast Iron Guides, Guides Included
Bore and Install Bronze Guides, Guides Included
Open 8 Pockets for Large Valves (No Seat)
Machine for Inner and Outer Springs
Machine for PC Seals
Chevy Screw in Studs

Piston Work

Glass Peen
CC Dome
Machine Dome
Notching Small Block Chevy Type
Left and Right Equal
Left and Right Different
Notch Big Block Chevy Type

• Plunge Notch 8 Valve Reliefs
• Install Double True and Spiro Locks (Locks Not Included)

Cut Top Land 2°
Mill Deck Surface Open Chamber BBC
Cut Skirt Tabs
Ring Grooves
Open Ring Grooves
Pressure Holes
Sand and Round Off Piston Domes (Head Matching Extra)

Connecting Rod Work

Press Off or Remove Locks & Boil
Align & Check for Out of Round
Assemble or Thermofit
Rod Work Package (includes all of the above)
Check Center to Center
Install New Bearings, Bore & Hone (Labor Only)
Bore Steel Rod, Install New Bearings, Bore & Hone (Labor Only)
Pin Rod Bearings
Magnaflux (Cleaning Extra)
Shotpeen
Side Clearance
Rebuild Rods
Install Bolts